[General] SMI/ISAMA 2013: Shape Fabrication & Sculpting Event

Call for Papers: SMI/ISAMA 2013: Shape Fabrication & Sculpting Event We invite you to submit a paper to Shape Fabrication and Sculpting Program, a joint event by Shape Modeling International (SMI) & International Society of The International Society of the Arts, Mathematics, and Architecture (ISAMA). This stream of papers, first featured at SMI'12, is targeted at practitioners such as architects and sculptors, providing a venue for describing methods and techniques relevant to their practice. We expect these submissions to pose new questions and to motivate further research in shape modeling. Papers accepted to this stream will be published in a special issue of the Hyperseeing magazine. This is similar to the publication of the SIGGRAPH art submission in the Leonardo journal. Practical paper presentations will be 15 minutes in length and they are likely to be presented in sessions that are held in parallel with some technical paper sessions. Specifically, the Fabrication and Sculpting stream seeks submissions presenting original research in all areas of sculpting and fabricating of shapes. For list of topics see <http://shapemodeling.org/index.html> http://shapemodeling.org/index.html and for examples of papers from 2012 event, see http://www.viz.tamu.edu/faculty/ergun/download/FASE/ Important Dates: Submission deadline: 1 April 2013 First decision notification: 21 April 2013 Revised papers submission: 7 May 2013 Final decision notification: 15 May 2013 Final copies submission: 29 May 2013 Submission Paper submissions should be made via the easychair conference management system at <https://www.easychair.org/account/signin.cgi?conf=smi2013fase> https://www.easychair.org/account/signin.cgi?conf=smi2013fase. For more information see <http://shapemodeling.org/submit.html> http://shapemodeling.org/submit.html Chairs: Ergun Akleman, Alexander Pasko